Custom Fabricated Edge Girder Floor Beam Picking Device
Early in the construction of a cable-stayed bridge project located in the New Jersey/ New York area, our customer contacted F&M MAFCO to provide fabrication and assembly of four lifting beams for their project. Due to the design of the bridge, not just any standard lifting beam could be used. The customer provided us with engineered drawings of a three-component beam that would be remotely controlled with the use of eight hydraulic rams.
This project was far from a typical fabrication job, the scope also included load testing of each component, procuring/installing a complete hydraulic control system, blast, prime, paint, assembly and finally shipping to the site. The multiple aspects of this job allow us to stand out utilizing our CAD detailer, fabrication shop, heavy equipment department, heavy equipment paint shop, and logistics department providing a single-source partner that the customer can rely on. Contact us to learn more about our custom fabrication services!
View All Projects
01 / 03
02 / 03
03 / 03